# A prior-contact check on your CRM misses mail your sequencer sent

A check for earlier outreach can come back clean for people already mailed, because the sequencer keeps its own log and never writes to the CRM.

By Ki Moon · 2026-11-16 · failure · current
Canonical: https://kihmoon.com/bench-notes/p/prior-contact-check-misses-sequencer-mail/

**Symptom:** A prior-contact check on the CRM and the mailbox graph reports no earlier outreach for a person your team already mailed.

Before a campaign I check whether anyone on the list was contacted before, and a first design that reads the CRM activity history and the mailbox graph, the standard places to look, can come back clean for people a sequencer already mailed. A sequencer with its own send log never touches the connected mailboxes or creates a CRM activity. The CRM only holds mail that a sync or a person logged there, and a sequencer is a third writer with its own record.

The failure is quiet since the check does not error. It returns an empty result that reads as never contacted, so the people the check was built to protect can get a second cold message.

Mail from a sequencer often does not pass through the rep's mailbox. Because many setups log to the CRM only for connected mailboxes, the send exists in exactly one place, the sequencer's own log.

The remedy is to treat every tool that mails people as a source for the prior-contact check. Read the CRM, the mailbox graph and each sequencer's send log together, and match on the person instead of the mailbox. A check that skips one source answers a smaller question than the one you asked.

A send log shows what the tool attempted, not replies handled elsewhere, so read both before you call a person fresh.

## Check your setup (read-only)

List the people your sequencer mailed in the last 30 days. Take the 10 most recently mailed. Look up each person in the CRM activity history and count the matches.

**Passes if:** Each of the 10 people has a CRM activity for the message, or the check also reads the sequencer log.

**Access needed:** crm-read, local-config

## If it fails (changes to make later, not part of the check)

1. List every tool and mailbox that mails people for your team.
2. For each one, find where it records a sent message.
3. Pick 10 people the tool mailed in the last 30 days.
4. Look up each person in the CRM activity history.
5. Count the people with no matching CRM activity.
6. Compare that count with the tool's own send log.

**Applies if:** You use a sequencer or a separate sending domain and a prior-contact check reads only the CRM or the mailbox graph.

**Skip if:** Every outbound tool logs each message to the CRM and your check already reads all of them.

Tags: crm, outbound, identity, gates
